Ⅰ. Brief introduction
The touch delay switch is an energy conservation electron switches which without touch point; using the clay influences the pressure to control the electrical appliance, and auto-cut off the electrical source by delay.
Ⅱ. Characteristic & Function
1. This switch’s center control adopted the electron component without touches point, can avoid the electrical current & spark, and can prolong the using time of the electrical appliance. The brightness can adjust finely, smoothly, softness, mnemonic, it can reach the effect that adjusts the bright with silence and no electricity, and the others don’t have this effect.
2. Improved circuit design, when adjust, it still keep fine and smooth, with twinkling.
3. The line avoid disturb inside, and have no effect to electrical appliance. Have a particular line to avoid creepage and get an electric shock, it is safety.
4. There are many kinds of aureole make you easy to find the place of the switch, and have a good effect to decorate you house.
5. This kind of switch is suit for many kind of place: hall light, bedlamp, reading lamp and so on.
Ⅲ.Technique guideline for the working pressure:
1. working pressure: AC180V—250V (50 / 60HZ)
2. nature use up: ≤0.5W
3. environment temperature: -20°C—50°C
4. Load power: please see the button of the switch.
5. packing size: 86*86*35mm
Ⅳ.Product installation
1. The switch adopt double line, the way of install is the same as the common switch. ( please see the attached drawing)
2. Please ask the professional electrician to install, and note to distinguish the front line and load line before install, error connection will make the switch out of gear or mangle. Please don’t stall with cut off the electrical source.
3. Please choose the right place to install.
4. After install, please check if the load short circuit or not, the charge of electrical appliance is suitable or not, if ok, you can switch on the electrical source.
Ⅴ. Using and attention.
1. the switch is working after finish install and connect the current, touch the touch slice more the 0.4 seconds to adjust the bright, the light become more and more bright, when it is the most bright, it become more and more dark. The bright will be remembered after unclinch the optional bright; if touch the slice less then 0.35 second your can control the switch to open or close the light, each time you open/close, the bright will be that it remembered before.
2. This switch is not suitable to use in these cases: high temperature, the pressure is not steady and dank place.
3. Our company only test with fluorescent lamp, if you use this switch in other light, we don’t assure the control effect.
4. Forbid connects the zero line and front line into the input and output port at one time.
|
|
|
|
|
