Ⅰ. Brief introduction
The touch delay switch is an energy conservation electron switches which without touch point; using the clay influences the pressure to control the electrical appliance, and auto-cut off the electrical source by delay.
Ⅱ. Characteristic & Function
2-1. this switch’s center control adopted the electron component without touches point, can avoid the electrical current & spark.
2-2. use you finger to touch the touch point, open the electrical appliance by this way, and it will auto-cut off after break away the touch slice in order to save electric energy.
2-3. it be setting the safety circuit in side to avoid creep age and get an electric shock, it is safety. It has many kind of indicator light; you can find the switch smoothly in dark.
2-4. this product can be applied in much kind of place which use lighting: different house, hotel, hall, corridor, basement and so on.
Ⅲ.Technique guideline for the working pressure:
3-1. working pressure: AC90V—250V (50 / 60HZ)
3-2. nature use up: ≤0.2W
3-3. environment temperature: -20—50°C
3-4. load power: please see the button of the switch.
3-5. packing size: 86*86*35mm
Ⅳ.Product installation
4-1. the switch adopt double line, can exchange with the common switch.
4-2. please ask the professional electrician to install, and note to distinguish the front line and load line before install, error connection will make the switch out of gear or mangle. Please don’t stall with cut off the electrical source.
4-3. please chooses the right place to install.
4-4. after install, please check if the load short circuit or not, the charge of electrical appliance is suitable or not, if ok, you can switch on the electrical source.
Ⅴ. Using and attention.
5-1. finish install, the switch is working after connect the electrical source, if influence the sound, the light begin delaying and illuminating. It will auto-close between 30 to 60 seconds.
5-2. this switch is not suitable to use in these cases: high temperature, the pressure is not steady and dank place.
5-3. forbid connects the zero line and front line into the input and output port at one time.
|
|
|
|
|
